- ページ 29

楽器 Yamaha Clavinova CLP-115のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha Clavinova CLP-115 46 ページ。 Yamaha keyboard user manual
Yamaha Clavinova CLP-115 にも：クイック・オペレーション・マニュアル (2 ページ), オーナーズマニュアル (46 ページ), ユーザーマニュアル (35 ページ)

ページを印刷する

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-

dance with the sequence given below.

• Assembly should be carried out by at least two persons.

• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (+) screwdriver ready

Remove the following parts from the package.

Assembly Parts

6 × 20 mm long screws ×4

6 × 16 mm short screws ×4

4 × 12 mm thin screws ×2

Main unit

Side

panel

Rear panel

(left)

Pedal box

Bundled pedal

cord inside

A headphone hanger is included in the CLP-115 package.

You can attach a headphone hanger on the CLP-115 to hang

the headphones (page 12).

4 × 20 mm tapping screws ×4

Cord holders × 2

Side

panel

(right)

AC power cord

TIP

Attach the side panels to the pedal box.

(2) Align the sides of the

Side panel

(right)

(3) Use the four

6×20 mm long

screws 1 to

attach the

pedal box.

(1) Untie and straighten out the bun-

dled cord attached to the bottom

of the pedal box.

Don't discard the twist tie, you'll

need it later in step 5.

Attach the rear panel.

Place the bottom edges

of the rear panel on the

feet's protruding edges,

with the panel slightly

angled as shown in the

illustration.

CLP-115

pedal box with the left and

right side panels.

Side panel

(left)

(1) Secure the top of the

rear panel to the side

panel brackets using

two 4×12 mm thin

screws 3.

(2) Secure the bottom of the

rear panel to the pedal box

using four 4×20 mm tapping

screws 4.