- ページ 31
楽器 Yamaha DISKLAVIER ENSPIREのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha DISKLAVIER ENSPIRE 35 ページ。
ページを印刷するTroubleshooting
Piano
Symptom
The Disklavier does not turn on.
Some notes drop out during
playback.
No sound is heard from the piano
even though piano keys are
moving.
Pedals are not moving.
The volume of the piano playback
is too low.
The piano playback and audio is
not synchronized with video
streaming.
The piano playback is not
synchronized with audio.
Pedal adjustment is inappropriate.
Piano keys are not moving.
Remedy
Make sure that the AC power cable is securely connected to a suitable
AC wall outlet.
Contact your local Yamaha customer service.
Disengage the quiet mode.
Tap on [Acoustic] on the Balance screen.
Disengage the quiet mode.
Tap on [Acoustic] on the Balance screen.
See page 22 on adjusting main volume.
See page 24 on adjusting the delay.
See page 25 on adjusting the delay.
See page 26 on adjusting the pedal.
Make sure that the audio volume of computer is adequately turned up.
Make sure that the surround system on your computer is TURNED
OFF. Audio enhancements prevent DisklavierTV from working properly.
Make sure that your computer is suitable for watching DisklavierTV
contents. See page 18 to try viewing a test video.
Make sure that the audio cable is correctly connected to the audio input
jack.
Make sure that the audio cable is firmly connected to the audio input
jack on your computer. If the symptom persists, connect the
headphones to the jack and try listening to audio playback to confirm
whether the jack is defective.
Replace the audio cable.
Reverse the left and right connection, and then check whether or not
the piano keys are moving.
Make sure that you are using the audio cable without impedance
changer.
In case you are using a USB audio interface, make sure that the USB
audio driver is correctly installed on your computer.
In case you are using a USB audio interface, make sure that USB audio
is selected in the audio device setting on your computer.
In case you are using a USB audio interface, make sure that the USB
audio output volume is adequately turned up.
In case you are using a USB audio interface, make sure that only the
input from your computer is connected to the USB audio interface. If the
input from any other device is connected, disconnect it or set its volume
to 0.
In case you are using a USB audio interface, make sure that the input
and output on the USB audio interface are correctly connected.
DisklavierTV User's Guide (For Disklavier ENSPIRE Users)
31