- ページ 31

楽器 Yamaha DTX500KのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha DTX500K 48 ページ。 Drum trigger module

ページを印刷する

Change the Reverb Type

This determines the Type of Reverb effect for each Drum Kit.

The same Reverb Type is applied to the entire Drum Kit.

* This setting affects the entire Drum Voice. The

is not shown in the upper right corner of the display.

Use the [

] button to call up the KIT20 page, then rotate the

jog dial to set the Reverb Type.

KIT20*

"RevType=hall1~‚

none .............. No reverb (same as thru).

hall1–5 ....... Simulates the reverb in a hall.

room1–5 ....... Simulates the reverb in a room.

stage1–5 ..... Simulates the ambience of a stage.

plate............ Simulates a steel plate reverb.

white............ A special short reverb effect.

tunnel ......... Simulates the reverb of a tunnel.

bsemnt ......... Simulates the reverb of a basement.

* The hall, room, or stage types with larger values produce a

more pronounced reverb effect.

Change the Reverb Level (3)

This determines the Signal Return Level from the reverb

effect for every Drum Kit. The same reverb type is applied to

the entire Drum Kit.

By setting the level, you can adjust the reverb effect for the

overall DTX500 system.

* This setting affects the entire Drum Voice. The

is not shown in the upper right corner of the display.

Use the [

] button to call up the KIT21 page, then rotate the

jog dial to set the Reverb Master Return level (0–127).

KIT21*

"RevMastRet=~64‚

Set the Pad Controller

This is effective only when a pad equipped with pad control-

ler is connected to the 1SNARE jack, and also when "SN-

1", "SN-2", "TM-1" or "TM-2" is assigned in the TRG2

˙/¶

indication

page (pad type) of the Trigger Setup pages.

The following settings can be made by rotating the pad con-

troller knob.

off .................No function is assigned.

snares ..........Adjusting the snares (also effective for the

tuning ..........Adjusting the tuning (also effective for the

tempo.............Adjusting the tempo

* The

the display.

Use the [

jog dial to set the Pad Controller function.

Set the Snares

This adjusts the snares effect (the characteristic sound of the

coiled wires on the bottom of an actual snare drum) of the

pad connected to the 1SNARE jack.

This also applies to pads not having a pad controller.

* The

the display.

˙/¶

indication

Use the [

jog dial to set the Snares adjustment level.

off .................Snares off (reproduces the sound with the

1–24 ...............Snares are applied to the sound; the higher

* When you change this setting, the decay setting (KIT6) for

the input sources "ƒsnare" and "ƒsnrOp" also changes.

7 Create Your Own Original Drum Kit

open rim sound)

˙/¶

indication is not shown in the upper right corner of

] button to call up the page KIT22, then rotate the

KIT22*

"PadCtl=snares~‚

˙/¶

indication is not shown in the upper right corner of

] button to call up the KIT23 page, then rotate the

KIT23*

"~~Snares=24~~~‚

snares lifted off the drum)

the value, the tighter the snares sound. (A

value of "1" is the "loosest" snares setting.)

DTX500 Owner's Manual