- ページ 6

楽器 Yamaha TP3323のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha TP3323 12 ページ。 Tp3300 series pedal timpani

ページを印刷する

1. Pedal Adjustment

Initial Preparation

Your Yamaha timpani is equipped with a plastic head carefully mounted and adjusted at the factory.

However, new heads tend to stretch during shipping and storage, so it may be necessary to re-tune the

instrument before using. Please perform the following steps to check and, if necessary, readjust your

instrument.

The area between the kettle edge and the inner

circle of the counter hoop is called the collar.

Please make sure that the width of this collar is

uniform, as shown in the illustration titled "Correct" .

Correct

Kettle

Counter

edge

Collar

hoop

If collar width is not uniform, fully depress the

heel end of the pedal. While holding the pedal

in this position, realign the head and hoop as

shown in the "Correct" illustration.

Caution

Never place your fingers or foot into the mov-

ing parts or the space under the pedal or

base.

Serious injury can result if fingers or feet be-

come pinched.

Wrong

Kettle

Counter

edge

Collar

hoop

Fully depress the heel end of the pedal. While

holding the pedal in this position, use the sup-

plied tuning key to tighten the tuning bolts one by

one ¼ of a turn (90°) in the order shown in the

illustration below.

It is very important that all tuning bolts be

turned the same amount.

Tuning key

29" , 32"

Take your foot off the pedal.

• Heel still moves up

→ Repeat steps

• Heel stays down

→ Go to step

23" , 26"

through