- ページ 11

楽器 Yamaha YG-2500のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha YG-2500 13 ページ。 Concert glockenspiel
Yamaha YG-2500 にも：オーナーズマニュアル (12 ページ), オーナーズマニュアル (13 ページ), オーナーズマニュアル (13 ページ)

Assembly

Adjustments

3-1

Pedal height adjustment

Loosen the center rod wing bolts (two each) on the right and left side center rods and hold the

pedal up to adjust the pedal height (the space between the bottom of the pedal and the floor).

After determining the height, hold the pedal and tighten the center rod wing bolts (two each) on

both right and left side center rods.

* 2-3cm of space between the bottom of the pedal and the floor should be adequate.

Pedal

Loosen the center rod wing bolts

3-2

Damper Adjustment

3-2-1

Rotate the damper adjustment nut 2 (thinner nut) to the left to unlock the damper ad-

justment nut 1 (thicker nut).

3-2-2

Rotate the damper adjustment nut 1 and adjust the damper (the amount of damper

applied to the tone bars).

Rotate the damper adjustment nut 1 to the left ...............Increases the amount of damper.

Rotate the damper adjustment nut 1 to the right ............Decreases the amount of damper.

3-2-3

After damper adjustment is complete, tighten the damper adjustment nut 2 to lock the

damper adjustment nut 1.

* If the damper adjustment nut 2 is not tightened firmly, the damper adjustment nuts can drop off or

cause noise.

* A half damper effect can be obtained by lessening the amount of damper until the sound slightly sus-

tains even though the pedal is not depressed.

Center rod wing bolts

Hold here while tightening the

center rod wing bolts

* If the space labeled "

10mm, the damper stopper will not function properly.

Make sure this space is more than 10mm.

Damper adjustment nut 1

Damper adjustment nut 2

" in the illustration is under