- ページ 9

楽器 Yamaha YM-410のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha YM-410 20 ページ。 Concert marimbas
Yamaha YM-410 にも：オーナーズマニュアル (19 ページ)

Insert the rails (2) and (3) into the frame ends of the legs.

2-1. First, insert the rail (2). Make sure that the end of the rail with the tone bar posts spaced further

apart is positioned on the bass side.

A mark "B" is printed on the large end face of the rail (2) and the groove section of the frame end

of the large end leg.

* Do not insert one side of the rail all the way down first, but push both sides into grooves alternately little

by little until both sides are inserted fully and stop.

Tone bar height can be adjusted at this point. (Refer to n on page 32.)

Rail (4): With YAMAHA logo. Logo side facing the audience.

High register side

2-2. After confirming that legs on the left and right sides are vertical, use the

screw to connect the end of the stay to the hole for attaching the stay in

the long frame (2) and firmly tighten the screw.

* The YM-410 and 410F have two (2) holes. When leg height is set low, use the

hole closer to the center of the instrument, and when the leg height is high,

use the outer hole and tighten the screw firmly.

2-3. Next, in the same way, insert the rail (3) securely.

A mark "C" is printed on the large end face of the

rail (3) and the groove section of the frame end of

the large end leg.

2-4. Engage the short rail clamp located at the center

of the rail (3) with the rail (2).

(3): Both sides have clamps attached. The side with the shorter clamp should face the player.

(2): Hole for attaching the stay. The side with the threaded hole should face the audience.

Audience side

YM-460/460F/410/410F/46/41/2400/2400R

(1)

ASSEMBLY

Tone bar posts

Player side

Frame end

Bass side

Rail (2)

Slant shaft