- ページ 5

照明器具 CALI alumLEDs ALS500T-DBR-TBのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CALI alumLEDs ALS500T-DBR-TB 11 ページ。

After all luminaires have been mounted, secure Aircraft Cable Assemblies to

luminaire by tightening lower hex nuts. All aircraft cables must rest in a vertical

position. Do not allow aircraft cables to rest at a slant or angle. Adjust as needed.

Note: The position of the Aircraft Cable Assemblies may deviate from the

spacing diagrams on page 6 due to variations within the installation area.

Ensure all luminaires are appropriately balanced.

Tighten hex nuts

to secure in place

Secure connections between continuous runs using Connector Blocks after all

luminaires have been mounted.

Note: Refer to steps on page 7 for details.

Install Ceiling Trim after all luminaires have been mounted and connected.

Note: Follow the steps on page 8 to install Ceiling Trim.

After all luminaires are mounted, adjust height and levelness of each luminaire

by adjusting cable gripper. Allow the weight of the luminaire to be suspended by

the aircraft cable while simultaneously resting on the flange of the T-Bar.

Note: One person holds the luminaire and another person adjusts cable gripper.

Adjust length as needed

Trim excess cable

Ceiling Trims resting on T-Bars

CALIFORNIA ACCENT LIGHTING, INC.

2820 E. Gretta Lane, Anaheim, CA 92806

ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com

ALS500T-DBR-TB

Mounting Luminaire (Aircraft Cable Assembly) 2 of 2

If applicable, position the driver in the center of luminaire and secure using set

screws (by others). Do not mount drivers between luminaires.

Note: Driver size and location of mounting holes may differ from below example.

If applicable, install mud-in end cap at end of run. The mud-in end cap is used

when the end of the luminaire terminates at drywall. Cut a hole in the drywall

where luminaire opening will be present. Only the main extrusion should be

exposed. Install mud-in end cap using countersink screws and ensure it is flush

with drywall. Apply mud to create a smooth, even surface.

Make wiring connections from driver to 1st PCB. Pull lead wires from luminaire

and make splice connections to lead wires from driver. Verify wiring diagram

before connecting.

Lead Wire

Perform a continuity test before connecting luminaire to power source.

Refer to page 10 for continuity test step by step.

Verify driver wire colors from wiring diagram, then connect luminaires to power

source. Drivers used for this product vary. Always confirm wiring diagram from

driver installation instructions before connecting.

INSTALLATION INSTRUCTIONS

1 / 29 / 2021 / Rev 2

Page 5 of 11