- ページ 11

照明器具 CALI alumLEDs ALS500T-SWM-TBのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CALI alumLEDs ALS500T-SWM-TB 20 ページ。

Do not install ceiling tiles until after installation of luminaires is complete.

Installation area must have at least 10" of overhead space.

Install T-Bar ceiling grid. Assemble the grid so there is a continuous edge

around grid for the Ceiling Trim to rest on. Hang the center of the T-Bar 6-5/8"

away from wall stud.

Wall Stud

5/8" Drywall

Hang or cut drywall along installation area so it is exactly 4" above ceiling line.

Note: Drywallers must hang drywall to the specifications. Only cut if necessary.

Mark locations along Wall Trim extrusion where it will be mounted to wall studs,

then drill holes as needed and mount to wall studs.

Note: Mount Wall Trim extrusion using at least 1 screw per 2', rounded up.

Mount Wall Trim

CALIFORNIA ACCENT LIGHTING, INC.

2820 E. Gretta Lane, Anaheim, CA 92806

ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com

Support Wire

T-Bar

Maintain

Continuous Edge

6-5/8"

Ceiling Line

ALS500T-SWM-TB

Mounting (Mounting Bracket Assembly) 1 of 2

Determine number of Mounting Brackets required.

Note: Refer to the diagrams on page 15 as a guide.

If applicable, assemble Mounting Brackets. Insert Hex Head Bolts through holes,

then place Lock Washer and Hex Nut on bolts. Leave the assembly loose for now.

Hang luminaire from mounted Wall Trim and hold in place. Have another person

slide Mounting Brackets onto luminaire and Wall Trim. Tighten bracket nuts

slightly so the bracket securely holds the luminaire in place. Do not tighten nuts

completely at this time.

Each Mounting Bracket secures

the luminaire to the Wall Trim

INSTALLATION INSTRUCTIONS

Hex Nut

Lock Washer

Hex Head Bolt

Hang luminaire

on Wall Trim

Hold in place

Slide Mounting Brackets

onto Luminaire

1 / 29 / 2021 / Rev 2

Page 11 of 20