- ページ 5

電子キーボード Yamaha Electone StageaのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Yamaha Electone Stagea 6 ページ。

Installing the version update data.

Press the [START] button in the Rhythm section on

the panel. The following display appears.

SYNCHRO

Conﬁrm the version number to be installed, then

press the [START] button to start installing the

version update.

SYNCHRO

The version update is complete when the completion

message below appears. Turn off the STAGEA and

disconnect the SmartMedia card or USB ﬂash

memory.

START

Supplemental instructions

If you are using a STAGEA with a version of 1.50 or

later, it is possible to delete the version update data in

the SmartMedia card or USB ﬂash memory with the

STAGEA.

Deleting the version update data

Insert the SmartMedia or USB ﬂash

memory with the version update data.

* With the terminal (gold-plated) part of the

SmartMedia card face down, insert it in the

card slot until a click sound is heard.

* Make sure to insert the SmartMedia card in

the correct position (up/down and front/

back).

* Check the connector of the USB ﬂash memory

device and insert it ﬁrmly into the USB TO

DEVICE terminal located under the keys.

USB flash memory

Simultaneously hold down the [START]

button in the Rhythm section on the panel

and turn on the power switch.

SYNCHRO

START

Keep holding down the [START] button until the

display below (or a similar one) appears.

USB

OPTICAL

TO DEVICE TO HOST

OUT

USB flash memory

POWER