- ページ 16

電子キーボード Yamaha KX88のPDF 正規製品マニュアルをオンラインで閲覧またはダウンロードできます。Yamaha KX88 38 ページ。 Midi master keyboard
Yamaha KX88 にも: オーナーズマニュアル (38 ページ), オーナーズマニュアル (38 ページ), サービスマニュアル (17 ページ)

Yamaha KX88 正規製品マニュアル
TS1 = A OCT UP, A OCT DOWN
Now let's assign a new function to the Toggle Switch 1.
(at present assigned to MONO, POLY) The Toggle Switches
TS1 and TS2 are different from the other controllers.
They can each be assigned two functions: one when pushed
on (LED lights up) and one when pushed off (LED goes
off). In this example, the two functions will be to transpose
MIDI bank A up and down an octave.
Enter CA mode by pressing the MODE switch.
Chose the controller. TS1 is not marked above the bank
A program select switches. So, press TS1. The upper
readout will display T1 for about 0.5 seconds, and then
the two present controller codes will be displayed.
Using the bank B program select switches, enter the
controller code for the first function. (08 A OCT UP)
The controller code you have just entered will be disp-
played in the upper readout.
Enter the controller code for the second function.
(0A A OCT DOWN) This will be displayed in the lower
readout for about 0.5 seconds and then it will return to
displaying CA.
Go back to PLAY mode and try out the new function
you have assigned. When you press TS1, the LED will
light and the tone generator receiving MIDI bank A will
play an octave higher than before. Press TS1 again. The
LED will go off and the tone generator will come back
down an octave.
This example used controller codes (08 and 09) that
were predefined to affect only one MIDI bank, but you
can set any assignment to affect either or both MIDI
banks.
CS1 = MASTER TUNE (bank A)
Let's make a controller assignment that will affect only
MIDI bank A.
Enter CA mode.
Press CS1. The upper readout displays C4 and the lower
readout displays the current controller code.
Notice that bank LED A and B are both on. This means
that this controller assignment is affecting both MIDI
banks. Press bank switch B, and the bank B LED will go
off.
Now enter the new controller code. (38 MASTER
TUNE)
This assignment will be active only for MIDI bank A.
Go back to PLAY mode and try it out. When CS1 is in
the center position, the two tone generators will be in
tune. As you move CS1, the tuning of the tone generator
receiving MIDI bank A will change. Try using the same
voice program for both tone generators, and you will get
a nice detune-chorus effect.
- 1 4 -