- ページ 4

レシーバー Yamaha Aventage RX-A720のPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha Aventage RX-A720 19 ページ。 Quick guide
Yamaha Aventage RX-A720 にも：クイックマニュアル (4 ページ), 特徴と仕様 (2 ページ)

ページを印刷する

Connecting speakers/subwoofer

• Under its default settings, the unit is configured for 8-ohm

speakers. When connecting 6-ohm speakers, set the unit's

speaker impedance to "6 Ω MIN". For details, see "Setting the

speaker impedance" in "Owner's Manual".

• Use a subwoofer equipped with built-in amplifier.

• Before connecting the speakers, remove the unit's power cable

from the AC wall outlet and turn off the subwoofer.

• Ensure that the core wires of the speaker cable do not touch

each other or come into contact with the unit's metal areas. This

may damage the unit or the speakers. If the speaker cables

short circuit, "Check SP Wires" will appear on the front display

when the unit is turned on.

■

Connecting speaker cables

Speaker cables have two wires. One is for connecting the

negative (–) terminals of the unit and the speaker, and the

other is for the positive (+) terminals. If the wires are

colored to prevent confusion, connect the black wire to

the negative and the other wire to the positive terminals.

a Remove approximately 10

mm (3/8") of insulation

+ (red)

from the ends of the

speaker cable and twist

the bare wires of the cable

firmly together.

– (black)

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side

(upper right or bottom left) of the terminal.

d Tighten the terminal.

Using a banana plug

a Tighten the speaker

Banana plug

terminal.

b Insert a banana plug into

the end of the terminal.

Connect the front speakers (1/2)

to the FRONT (//\) terminals.

The unit (rear)

FRONT

AUDIO

OUT

F R

O N

a a

F R

O N

SPEAKERS

CENTER

SURROUND

SURROUND BACK/BI-AMP

ZONE 2/PRESENCE

SINGLE

EXTRA SP

AC IN

ZONE 2

SUBWOOFER

OUT

Connect the center speaker (3) to the

CENTER terminal.