- ページ 4

アンプ Yamaha AX-330eのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha AX-330e 8 ページ。 Natural sound stereo integrated amplifier
Yamaha AX-330e にも：オーナーズマニュアル (9 ページ)

ページを印刷する

The connection diagram is provided on page 3.

@ Video player

@ Speakers

©) Tape deck

{1} Compact disc player

Before making any connections turn off all equip-

ment.

Be sure to connect the left (L) and right (R) channels

consistently between components.

@ CONNECTING THE SPEAKERS

To listen through headphones, use SWITCHED

SPEAKERS terrninals. No sound will be emitted from

the speakers if headphones are connected to the

unit.

To listen directly from the speakers, use DIRECT

SPEAKERS terminals. Sound signals will then be

output as pure, more direct sounds, without passing

through the headphones output circuit.

Note that both terminals should never be used at the

same time, because to do so might result in a mal-

function.

Connect the cords for the left speakers to the L ter-

minals and the right speaker cords to the R termi-

nals, ensuring that the polarity (+ and —) markings

are observed. If the polarity is reversed at either

speaker the sound will be unnatural and lack bass.

Speaker cords should be cut as short as possible.

Avoid coiling the wire on the floor or bundling it up

with cords from other system components.

When connecting to SWTCHED SPEAKERS termi-

nals

Strip off about 10 mm (3/8 in) of the insulation

(leaving only the core wire) from the end of each

speaker connection wire to be connected to this unit.

Press the lever below one of the SPEAKER con-

nection terminals and insert this exposed core wire

into the hole, as shown in the illustration. When the

lever is then released, the cord is locked in securely.

RED for (+) sign.

BLACK for ( —) sign.

When connecting to DIRECT SPEAKERS terminalis

Simply insert the Banana Chip connector into the

corresponding terminal.

e CONNECTING A TURNTABLE

Connect the output cords of the turntable to the

amplifier Phono jacks and connect the ground wire |

to the GND terminal.

Normally connecting the

ground wire produces minimum hum but in some

cases better results are obtained with the ground

wire disconnected. The turntable component and iis

output cords should be positioned well away from

sources of hum such as power cords or power

transformers of other system components.

Connect the cords from the Tuner's output jacks ti

the TUNER jacks of the amplifier. As the amplifier

power supply may generate a certain amount of

radio frequency noise, position the tuner so that il

AM antenna is well away from the amplifier.

e CONNECTING TO THE CD AND VCR/AUX JACK

Connect your CD component to the CD terminals ar

video sound output leads the VCR/AUX terminals.

Please note that a turntable cannot be connected :

these jacks as they do not provide the necessary

RIAA equalization.

Connect the tape deck's Line In jacks to the

amplifier's Rec Out jacks, ensuring that left and rig:

are not reversed. Then connect the tape deck's Lir

Out jacks to the amplifier's Tape PB jacks.