コントローラー DirectConnect VCIR70DSWのPDF 使用方法をオンラインで閲覧またはダウンロードできます。DirectConnect VCIR70DSW 3 ページ。 12 step 70w vc w/ir impedance & non-impedance infrared stereo volume control

ページを印刷する

INSTRUCTIONS

12 Step 70W VC w/IR Impedance & Non-Impedance

Infrared Stereo Volume Control

Model: VCIR70DSW

SKU# .10258

Features:

•

Infrared stereo volume control with selectable

impedance and non-impedance matching-

1x, 2x, 4x, 8x

•

Covers prepackaged with decorator white

plates.(Optional color kit plates available in ivory,

almond and brown)

•

Power handling: 70 watts per channel RMS

•

12 step Volume Control

•

Removable connectors accommodate 14 – 22 gauge

wire

•

Two sided terminal connector

Instruction

1. Remove about 1/4" of insulation from the ends of all wires to be connected to the volume control and twist the

exposed strands.

2. Loosen the set screws on the volume control connecting blocks.

3. Connect the leads from AMPLIFIER to the set screws on the volume control labeled INPUT, with the LEFT L(+)

and L(-) and RIGHT R(+) and R (-) wires inserted in the appropriately marked opening. Tighten the screws

firmly.

Connect SPEAKER wires to the set screws on the volume control labeled OUTPUT, observing + (positive) and

- (negative) polarity of left and right speaker.

5. Set up the completed assembly in the junction box. Insert carefully to avoid excessive strain on the set screws. If

necessary, pre-dress the wires for easiest mounting.

6. For setting up IR receiving – release screw of connector, insert wires respectively for connection, then tighten

the screws firmly.

" V+"

- 12VDC power;

" G "

- Grounding;

"ST "

- Status (IR receiving confirmation);

"IR "

- IR signal

7. Mount VC into wall box. Insert carefully to avoid excessive strain on these screws.

8. Screw on trim plate and attach knob.

Caution: Be careful not to allow speaker wire strands to short out against case or other speaker wire.

DirectConnect

4747 Westpark Houston, TX 77027

Tel: 800-531-3224

Fax: 713-525-3220