- ページ 6

扇風機 aerauliqa Quantum EX 100 HTのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。aerauliqa Quantum EX 100 HT 16 ページ。

• Install the product so that the impeller is not accessible from the air outlet side as

veriﬁed by contact with the Test Finger (test probe "B" of the norm EN61032) in

compliance with the current safety regulations.

• Window installation

In case of window installation it is necessary to use the appropriate window kit, which

is not included.

Attention: do not mount the product on the window without this kit.

INTRODUCTION

Quantum EX is an axial fan, silent operation, designed for continuous running and to ensure air extraction

in small/medium-sized rooms such as bathrooms, toilets, and kitchens. Suitable for air discharge in the

presence of short linear duct. Wall, ceiling or window installation (fig.1).

TECHNICAL SPECIFICATIONS

• Material: high quality, impact and UV-resistant ABS colour RAL 9010.

• Design front cover removable for cleaning without the use of tools.

• High efﬁciency aerodynamic fan with "winglet" blades to optimise quietness and efﬁciency.

• Single phase EC Brushless motor for energy saving, with integral thermal protection.

• Motor mounted on high quality ball bearings.

• Selectable minimum speed for continuous running and intermediate speed.

• Maximum speed selectable through LS connection.

• Selection of smart humidity control and intelligent run-on timer.

• Suitable for continuous running.

• The fan is double insulated: no earth connection is required.

• IPX4 wall installation; IPX2 ceiling installation.

• Power supply 220-240V~ 50/60Hz

Upon power-up, the unit runs at the minimum continuous speed.

If humidistat or timer is activated, the unit runs at the intermediate speed.

If the external switch is activated, the unit runs at the maximum speed.

After the external switch is off, the unit continues to run at the intermediate speed for a period of time, then

it returns to the minimum speed (or to the intermediate speed in case humidistat or run-on timer operation

is on). The led on the front cover support lights up when the external switch is activated.

The functionalities can be set/enabled through the Dip Switches A and B on

the electronic circuit.

Attention: during this operation the unit needs to be disconnected from the

main power supply.