- ページ 14

オフロード車 Yamaha YX10ZXPSL 2020のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha YX10ZXPSL 2020 21 ページ。

ページを印刷する

[To enter the shift light control mode]

1. Turn the key to "

2. Push and hold the "MODE" button.

3. Turn the key to "

the "MODE" button after all segments of the

display disappear and the shift light comes

on. The shift light can be adjusted as follows.

[To set the flashing pattern]

1. Push the "RESET" button to select one of the

following flashing pattern settings:

• On: the shift light stays on when activated.

(The shift light will confirm this setting by stay-

ing on.)

• Flash: the shift light flashes when activated.

(The shift light will confirm this setting by

flashing four times per second.)

• Off: the shift light is deactivated; in other

words, it does not come on or flash. (The shift

light will confirm this setting by flashing once

every two seconds.)

2. Push the "MODE" button to confirm the se-

lected flashing pattern. The control mode

changes to the activation point setting mode.

The shift light remains on and the tachometer

shows the current setting r/min for the activa-

tion point.

[To set the shift activation point]

TIP

• The shift light activation point can be set be-

tween 7000 r/min and 12000 r/min. The activa-

tion point can be set in increments of 500 r/min.

• The tachometer needle will start over at 7000 r/

min after 12000 r/min.

1. Push the "RESET" button to select the de-

sired engine speed for activating the shift

light.

2. Push the "MODE" button to confirm the se-

lected engine speed. The shift light flashes

and the tachometer shows the current setting

r/min for the deactivation point.

[To set the deactivation point]

TIP

• Be sure to set the deactivation point to a higher

engine speed than for the activation point, oth-

erwise the shift light will not come on.

• The shift light deactivation point can be set be-

tween 7000 r/min and 12000 r/min. The deac-

tivation point can be set in increments of 500 r/

min.

" (off).

" (on), and then release

• The tachometer needle will start over at 7000 r/

min after 12000 r/min.

1. Push the "RESET" button to select the de-

sired engine speed for deactivating the shift

light.

2. Push the "MODE" button to confirm the se-

lected engine speed. The display exits the

shift light control mode and returns to the

standard multi-function display mode.

Fault code display (YXZ1000E)

1. Fault code display

2. Engine trouble warning light "

This model is equipped with a self-diagnosis de-

vice for various electrical circuits.

If a problem is detected in any of those circuits,

the engine trouble warning light will come on or

flash, and the display will indicate a fault code.

If the display indicates a fault code, note the

code number, and then check the fuel injection

system.

Refer to "FUEL INJECTION SYSTEM" on page

9-43.

ECB02030

NOTICE

If the display indicates a fault code, the vehi-

cle should be checked as soon as possible

in order to avoid engine damage.

Fault code display (YXZ1000ET/YX10ZXPSL)

1. Fault code display

2. YCC-S system fault code display

1-5

FEATURES