- ページ 17

スピーカーシステム Yamaha DXS15XLFのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha DXS15XLF 31 ページ。 Powered loudspeakers/subwoofer
Yamaha DXS15XLF にも：オーナーズマニュアル (31 ページ), オーナーズマニュアル (31 ページ), オーナーズマニュアル (31 ページ)

ページを印刷する

Installation Examples

CAUTION

• Before doing any installation or construction work, consult with your Yamaha dealer.

• The installation should be checked thoroughly at regular intervals. Some fittings may deteriorate over extended periods of

time due to wear and/or corrosion.

• When choosing the installation location, suspension wire and mounting hardware, make sure all are strong enough to

support the weight of the speaker.

• Make sure to take precautionary measures using wires to prevent the speaker from falling down in the event of an installa-

tion failure.

• When installing the wire to the wall, install it higher than the wire's attachment point on the speaker, with as little slack as

possible. If the wire is too long, and the speaker happens to fall, the wire may snap as a result of too much strain.

• Make sure to use eye bolts according to the standards and safety regulations in your area.

Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure or

improper installation.

Suspended Installation Using Eye Bolts

Attach commercially available long eye bolts (30–50 mm in

length) to the screw holes for the eye bolts (e on page 7). The

screw diameter for DZR315(-D), DZR15(-D), and DZR12(-D) is

M10, and the screw diameters for DZR10(-D) are M10 and M8.

Keep in mind that you will need two or more rigging points.



Securing the eye bolts

Insert the eye bolts through the washers when attaching

them.

NOTE

• The screw holes for eye bolts go through the cabinet wall.

• When using eye bolts, remove the flat-head screws tightened at

the time of factory shipment. When not using eye bolts, tighten

the flat-head screws in order to prevent air leaks.



Suspension angle

Make sure to use eye bolts within a range of 0 to 45 degrees from a right angle.

0°

45°



Suspended installation example

M10 eye bolt

Max. 45°

Side

Bottom

Max. 45°

Pullback point

Full range

Apply thread-

locking fluid

to the eye bolt

Rear