- ページ 8
スピーカー Caliber 35460のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Caliber 35460 14 ページ。 Snap lock in-wall/in-ceiling speakers
ページを印刷する
In many cases, the mark is a single stripe on the jacket of one of the connectors. In this
case the side with the stripe is generally
considered the positive side, but it really does not
matter as long as you are consistent and always
use the stripe as positive or always use it as
negative.
When you are ready to prepare your speaker
wires, first separate about 4" of wire, then strip
about 1/4" (6mm) insulation from the end and twist it to prevent stray strands. If you plan
to use banana or pin plugs (highly recommended), install the plugs on the wire.
PAINTING
The grilles can be painted to match your walls or ceiling, making the speakers even less
noticeable. Perform the following steps to safely paint them without damaging the
speaker.
1. Pull on the edge of the magnetic grille to remove it from the speaker.
2. Paint the speaker grille. It is best to use spray paint to avoid paint clogging the
holes in the grille.
3. Allow the paint to completely dry before proceeding with installation. Ensure that
the holes in the grille are not blocked by paint.
Positive
Red
Copper
╋ ╋ ╋
8
Negative
Black
Silver
━ ━ ━