- ページ 8
ソーラーパネル ACOPOWER HY-PTK-100WP20AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ACOPOWER HY-PTK-100WP20A 14 ページ。
ページを印刷する
①
②
③
④
⑤
2. Indicators Description and Operation
2.1 Indicator Status Description
Charging Status
LED indicator
Battery Status LED
indicator
Radix Point of Digital
tube
(Load indicator)
2.2 Operation
Digital
Key
Tube
1) After Powering on, disconnect the PV or connect the PV(Voltage<5V) , the light of the digital tube point go on;
Connect the PV(Voltage>6V) ,the light of the digital tube point go off.
2) The key can be used to operate switching on/off the load (Manual control) or clearing the faults
3) Keeping pressing the key button over 5S, It will go to the parameter in browsing mode which can cycle through
the parameter item by clicking the button ,after the light of the digital tube point going on.
4) After the digital tube displaying the value what you want to configure, releasing the key and waiting 15S, Digital
Tube stop flashing, then the configuration is successful.
www.ACOPower.com
Green
Green
Green
Green
Green
Green
Orange
Red
Red
Red
Red
The digital tube display the load work mode, please refer to the correspondence table of
Load Work Mode & LED digital tube value. Pressing the key to configure the parameter,
please refer to the below configuration method:
HY-PTK-100WP20A
PV connection normal
On Solid
but low voltage(irradiance)
from PV, on charging
NO PV voltage(night time)
OFF
or PV connection problem
Slowly Flashing
Fast Flashing
On Solid
Slowly Flashing
On Solid
On Solid
Over discharged
On Solid
Slowly Flashing
Fast Flashing
4120 Valley Blvd Walnut, CA 91789, USA
In Charging
PV
Over voltage
Normal
Full
Under voltage
Load ON
Over Load
Short Circuit
+1-626-737 1140