- ページ 5
自動車アクセサリー Directed XpressKit DBALLのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Directed XpressKit DBALL 11 ページ。 Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL にも： インストレーション・マニュアル (16 ページ), マニュアル (14 ページ), インストレーション・マニュアル (16 ページ), マニュアル (19 ページ)
ページを印刷する
Platform: DBALL/DBALL2
Firmware: HK2
Module Programming
Refer to the LED Diagnostics section on pages 8-9 for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the Flash Module button.
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
When the flashing operation is successful, you can proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
OR
W2W Installation
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
Wait until the LED turns ON solid red.
1
Note: To skip the transponder programming and use convenience
feature only, press the programming button 5 times. The LED will
turn orange then proceed to step 4.
Turn the key to the ON position.
2
The LED will flash green then solid green for 3 seconds, and then
turns OFF.
If the vehicle doesn't have a transponder, the LED will remain
solid red. Press the programming button 5 times to skip the
transponder programming.
3
The LED turns ON solid orange for 3 seconds then shuts off when
programming is done.
4
Turn the key to the OFF position and remove it from the ignition.
You have successfully completed the module programming sequence.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your XKLoader3.
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select FLASH YOUR MODULE and follow the on screen
instructions.
th
4
st
1
st
1
Key IN
Rev.: 20160829
rd
3
nd
2
rd
3
nd
2
&
&
&
START
Flash
Green
Green
3 seconds
&
Press
x5
Solid Red
&
Orange
Off
3 seconds
Key OUT
START
© 2016 Directed. All rights reserved.
Page 5
Solid
Off