- ページ 16

ページを印刷する

Quick Reference Guide

DBALL2-

HYUNDAI4

Remote Start Ready (RSR) Installation

Vehicle Takeover

Press the remote start button on the transmitter to

start the vehicle.

Press the Unlock button on the factory

or aftermarket remote.*

Complete the following steps within 45 seconds

or the vehicle will shut down.

Enter the vehicle, while making sure the

factory remote is inside with you.

Press the

PTS

button twice to turn the

ignition

Press the brake pedal, put the car

in gear and drive off.

* Your aftermarket remote may differ from the model shown in the illustrations.

Press

remote start

button

Press Unlock

button

either remote*

Enter vehicle

with Smart Key

ENGINE

PUSH

START

STOP

Ready to

drive off

Pit Stop Mode

The

Pit Stop

Mode feature is practical when you need to stop and run an errand,

but wish to keep the engine running.

Stop the vehicle in a safe parking spot

and put the gear in Park (P).

Press the button to remote start the vehicle.*

The

PTS

button will

flash once to

indicate the vehicle is now in P

Mode

It is now safe to leave the

vehicle with the

factory remote

Note: We recommend that you always lock the doors

of your vehicle when leaving it unattended.

* Your aftermarket remote may differ from the model shown in the illustrations.

Parking Light Error Codes

The parking lights on your vehicle will flash a specific number of times 3 seconds

following an unscheduled shutdown

described below.

Flashes

Diagnostic

Runtime expired.

Over-rev shutdown.

Low/No RPM.

Transmitter shutdown.

Brake shutdown.

Hood shutdown/Remote start safety override switch is ON*.

Remote start safety override switch is ON*.

* If the vehicle hood status is supported through data, safety override switch input

will report 7 flashes.

Stop & put vehicle in Park (P)

Press

remote start

it Stop

button

engine running and

exit

the

in hand.

xit

vehicle with

Smart Key

or failure to start

. Each flashing pattern is

ENGINE

START

STOP

Flashes