- ページ 9

ページを印刷する

Directed Xpresskit DBALL2 インストレーション・マニュアル

Platform: DBALL2

Firmware:

CHRYSLER Remote Start Ready

Module Reset

A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed

to the module using the web config tool will not be affected.

If required for your installation, connect the 10-pin & 12-pin

harnesses to the module Press

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the

rogramming button.

Hard Reset

Warning gainst xecuting a Hard Reset!

A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such

RFTD

and D2D options) may have to be reconfigured. See the

If required for your installation, connect the 10-pin & 12-pin

harnesses to the module Press

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the

until the

LED starts to flash orange

Release the programming button. The

and

hold the rogramming

LED turns

solid

orange then release the

The

LED

turns

solid red.

and

hold the rogramming

LED turns

solid

orange

and

red.

LED

turns

(RSR)

Installation

Feature & Option List

, and w

ait

10 more seconds

solid red.

Rev.: 20170817

Solid

Release

Solid

section of this guide.

Solid

Flashes

Release

Solid

Page 9