- ページ 10

トリマー ALDI GLT5529のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。ALDI GLT5529 12 ページ。 Electric grass trimmer

ページを印刷する

1. General Information

10b

Using the grass trimmer as an edge trimmer

(Fig. 9)

To cut the edges of lawns and flower beds, the grass trimmer can be

converted as follows:

•

Set the angle of the handlebar to its lowest position as previously

described - see (Fig. 4/Item A)

•

Turn the top handle through 90° as previously described

- see (Fig. 9/Item A)

Replacing the power cable

If the power cable for this equipment is damaged, please contact

our after sales support team or similarly trained personnel to avoid

danger.

Cleaning, maintenance and ordering of spare parts

Always pull out the mains power plug before starting any cleaning work.

Cleaning

Keep all safety devices, air vents and the motor housing free of dirt, debris

•

and dust as far away as possible.

Wipe the equipment with a clean cloth or blow it with compressed air at low

•

pressure.

We recommend that you clean the device immediately each time you have

•

finished using it.

AFTER SALES SUPPORT

0151 649 1500

(Charged at local rates)

www.einhell.co.uk

1890 946 6244

IRE

MODEL NUMBER: 7446, 08/2011, GLT5529

•

Clean the equipment regularly with a moist cloth and some soft soap. Do

not use cleaning agents or solvents; these could attack the plastic parts of

the equipment. Ensure that no water can seep into the device.

•

Use a brush to remove deposits from the safety guard.

Replacing the line spool

Important.

Ensure that you pull out the power plug before replacing the line spool.

•

Press the sides of the spool cover as shown and remove the cover

(Figure 10a).

Remove the empty line spool.

•

Thread the ends of the line on the new line spool through the eyelets in the

spool cover (Fig. 10b) and allow approx. 10 cm of line to project.

•

Fit the spool cover and spool back into the spool mounting.

•

When you start the equipment again, the line will be cut to the perfect

length automatically.

Important. Bits of the nylon line could cause injury when being flung out.

use injury when being flung out.

Maintenance

There are no parts inside the equipment which require additional

maintenance.

Ordering replacement parts

Please quote the following data when ordering replacement parts:

•

Type of machine

•

Model number of the machine (34.015.38), can be found on the

product label.

Identification number of the machine (11011), can be found on the

•

product label.

•

Replacement part number of the part required, can be found on the

parts parts list (page 11 of user guide).

•

For our latest prices and information please go to www.einhell.co.uk

Spare line spool Art. no.: 34.050.70

•