- ページ 11

電動工具 Clarke 3110550のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 3110550 17 ページ。 Air shears

ページを印刷する

TROUBLESHOOTING

SYMPTOM

Tool runs at normal

speed but slows down

under any load.

Tool runs slowly. Air flows

weakly from exhaust.

Tool will not run. Air flows

freely from exhaust.

Tool will not shut off.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

PROBLEM

1. Excessive pressure on

tool.

2. Motor parts worn.

3. Worn or sticking

mechanism due to

lack of lubricant.

1. Motor parts jammed

with gum/dirt.

2. Regulator in closed

position.

3. General airflow

blocked by dirt.

1. Motor vanes stuck

due to buildup of

foreign material.

1. Throttle O-rings

damaged or ill-fitting

in seat.

SOLUTION

1. Reduce the force

applied to the tool.

2. Return to Clarke dealer

for repair.

3. Drip air tool lubricating

oil into air inlet. Allow oil

to soak moving parts

before using.

1. Examine inlet air filter for

cleanliness.

2. Adjust regulator to open

position.

3. Operate tool in short

bursts.

1. Disconnect air supply

and rotate tool assembly

manually.

2. Try operating tool in

short bursts.

3. Tap motor housing gently

with a rubber mallet.

4. Drip a few drops of air

tool lubricating oil into air

inlet to soak moving

parts.

1. Return to Clarke dealer

for repair.