- ページ 4

リモートスターター Directed 1475のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Directed 1475 12 ページ。 4­ button automatic / manual transmission remote starter

Directed 1475 ユーザーマニュアル
Using the ASRA2403 Remote Control 
Your Remote Car Starter is equipped with a 4-button multi-channel remote control. It can operate
two independent vehicles equipped with the same Remote Car Starter (see Multi-Car Operation
section (page-10), later in this Guide, for second-car transmitter functions).
The functions of the transmitter are as follows:
Vehicle Presets 
Heater & Heated Seat 
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on HIGH. It is recommended to leave the settings on LOW or
MEDIUM instead.
Windshield Wipers, Radio & Headlights 
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are
. Leaving the headlights switch
on certain
OFF
ON
types of vehicles could cause them to remain
even after remote starter shutdown, resulting in a
ON
dead battery.
Remote­Starting Your Vehicle 
Setting Your Vehicle Into Ready Mode 
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle. Please note that Ready Mode can be enabled by the
remote or the handbrake, depending on the option that was selected by your installer. Therefore,
you must follow the appropriate procedure between the two described below in order to set your
vehicle into Ready Mode.
P. 4
User Guide