- ページ 9

電動工具 Clarke 6500010のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6500010 14 ページ。 Mortising machine

ADJUSTING HOLD DOWN

The purpose of the hold down in to prevent the workpiece from lifting as the chisel is raised up,

out of the hole. The hold down should be adjusted so it just touches the top of the workpiece

and allows the workpiece to slide left or right. The hold down can be turned upside down to

accommodate thicker workpieces. To adjust the hold down, loosen the set screw (A) with the

Allen key provided, position the hold down, and re-tighten set screw (A).

ADJUSTING DEPTH STOP ROD

A depth stop rod is provided to limit the

depth of the chisel cut. To adjust the depth

stop rod, loosen the set screw (B) and lower

the head until the bottom of the chisel is at

the desired depth. Lower the depth stop rod

until it contacts base and re-tighten screw

(B, Fig. 7).

Fig 8

ADJUSTING SLIDING FIT BETWEEN HEAD AND COLUMN (Ref fig. 9)

Two bolts are provided on the rear of the head, to ensure a good sliding fit between head and

column when the head is raised and lowered. Adjustment is made by loosening or tightening

these two bolts. NOTE: Correct adjustment is when a good snug sliding fit is obtained without

any side movement between the head and column. The adjustment should not be too tight

that it restricts the sliding movement, or too loose that it affects accuracy. There are also two

set screws, located on the side of the head, which can be adjusted. These two screws keep

the head and column in good alignment. If there is excessive movement in this area:

1. Loosen the lock nut, securing the set screw.

2. Screw the set screw in, until movement is eliminated.

3. Secure the set screw in this position by re-tightening the lock nut ,whilst holding the set

screw to prevent it from turning.

Fig 7

ADJUSTING CHISEL PARALLEL TO

The chisel can be adjusted parallel to

the workpiece by loosening the securing

screw and rotating the chisel until the

back surface of the chisel is flat against

the workpiece. Then re-tighten the

screw.

WORKPIECE