- ページ 13

ラミネーター ALDI OL 250-LのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ALDI OL 250-L 19 ページ。 A4 laminator

− Do not leave any laminating pouches in or next to the

laminator after lamination.

When using the laminator, a slight odour may be produced. Ensure

there is sufficient ventilation in the room, e.g. by opening windows.

Laminating

1. Move the ON / OFF switch

The ready indicator will turn from dark blue to red within the next 1 ½–2 minutes.

2. Once the ready indicator

the laminating pouch

Make sure that the document is flush with and aligned as close as possible to the

sealed edge of the laminating pouch.

3. Insert the laminating pouch so that it is centred and with the closededge first

into the laminating pouch infeed slot

The heating rollers will automatically pull the laminating pouch in and move it to

the laminating pouch output slot

to pull out the laminating pouch.

4. Remove the laminating pouch and let it cool off briefly on a flat surface.

− If necessary, you can cut off excessive material after it has cooled

− Repeat the process if the laminating pouch has not adequately

5. Move the ON / OFF switch to "OFF" ( ) to switch the laminator off.

The laminator is equipped with an antiblocking system. If the laminating pouch was

not inserted straight or it becomes jammed in the laminator, proceed as follows:

1. Move the ABS switch

it down (see fig. C).

2. Pull the laminating pouch

It is recommended you pull the laminating pouch out in the direction

of its larger end.

You can place the document in a new laminating pouch and laminate it again.

to "ON" (―) (see fig. B).

is red, place the document between the two sides of

off.

adhered to the document.

towards the laminating pouch infeed slot

out of the laminator.

on the back of the laminator.

on the front of the laminator. Don't use force

Operation

and hold