- ページ 7

電動工具 Clarke CAT91のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CAT91 8 ページ。 Air ratchet wrench
Clarke CAT91 にも：取扱説明書 (17 ページ)

ページを印刷する

Employers are advised to refer to the HSE publication "Guide for Employers".

All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator

via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 herz is potentially

damaging and is most hazardous in the range from about 5 to 20 herz.

Operators who are regularly exposed to vibration may suffer from Hand Arm Vibration Syndrome

(HAVS), which includes 'dead hand', 'dead finger', and 'white finger'. These are painful

conditions and are widespread in industries where vibrating tools are used.

The health risk depends upon the vibration level and the length of time of exposure to it......in

effect, a daily vibration dose.

Tools are tested using specialised equipment, to approximate the vibration level generated under

normal, acceptable operating conditions for the tool in question. For example, a grinder used at

45° on mild steel plate, or a sander on softwood in a horizontal plane etc.

These tests produce a value'a', expressed in metres per second per second, which represents the

average vibration level of all tests taken, in three axes where necessary, and a second figure 'K',

which represents the uncertainty factor, i.e. a value in excess of 'a', to which the tool could

vibrate under normal conditions. These values appear in the declaration on page 7.

You will note that a third value is given in the specification - the highest measured reading in a

single plane. This is the maximum level of vibration measured during testing in one of the axes,

and this should also be taken into account when making a risk assessment.

'a' values in excess of 2.5 m/s

tool with a vibration value of 2.8 m/s

whereas a tool with a value of 11.2 m/s

The graph below shows the vibration value against the maximum time the respective tool may

be used, per day.

The uncertainty factor should also be

taken into account when assessing a

risk. The two figures 'a' and 'K'may

be added together and the resulant

value used to assess the risk.

It should be noted that if a tool is used

under abnormal, or unusual

conditions, then the vibration level

could possibly increase significantly.

Users must always take this into

account and make their own risk

assessment, using the graph as a

reference.

Some tools with a high vibration value, such as impact wrenches, are generally used for a few

seconds at a time, therefore the cumulative time may only be in the order of a few minutes per

day. Nevertheless, the cumulative effect, particularly when added to that of other hand held

power tools that may be used, must always be taken into account when the total daily dose rate

is determined.

HAND-ARM VIBRATION

are considered hazardous when used for prolonged periods. A

may be used for up to 8 hours (cumulative) per day,

may be used for ½ hour per day only.

- 7 -