- ページ 8

電動工具 Clarke CIR450BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CIR450B 16 ページ。 Professional cordless impact wrench

BATTERY CHARGING

1. The new battery pack will require

charging before use.

2. Squeeze the battery release buttons on

either side of the battery pack and pull

gently down to disengage the battery

pack from the machine as in Fig 1.

3. Insert the battery pack into the battery

charger, as shown in Fig 2, noting that it

will only fit one way.

4. Plug the charger into a 230v (mains)

power supply and switch ON.

• The green POWER ON light will

illuminate to show the unit is

connected to the mains supply. The

RED charging light will illuminate and

charging will begin.

• If charging does not take place,

ensure all connections are clean

and free of grease etc.

• If the red charging light will not stay on for more than a few

moments, the battery pack is likely to be defective and it must be

replaced with a new one.

• When charging is complete (typically

after about 1/2 hour), the RED charging

light goes off. The battery pack can be

considered charged and be removed.

The charging time will be dependant

upon the initial state of the batteries.

When charging a new battery pack it

may initially not accept full charge. This is

common & does not indicate a fault. It

can be recharged fully after it has been

discharged a couple of times.

5. After charging, switch off and unplug the

charger from the power supply.

6. Remove the battery pack from the

charger and slide it back into the machine

until it clips into place.

FIG 1

FIG 2