- ページ 6
電動工具 Clarke cp185のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke cp185 16 ページ。 Sander/polisher
ページを印刷する
ELECTRICAL CONNECTIONS
WARNING! Read these electrical safety instructions thoroughly
before connecting the product to the mains supply.
Before switching the product on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate. This
product is designed to operate on 230VAC 50Hz. Do not connect it to any
other power source.
This product may be fitted with a non-rewireable plug. If it is necessary to
change the fuse in the plug, the fuse cover must be refitted. If the fuse cover
becomes lost or damaged, the plug must not be used until a suitable
replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or
due to damage, it should be cut off and a replacement fitted, following the
wiring instructions shown below. The old plug must be disposed of safely, as
insertion into a mains socket could cause an electrical hazard.
WARNING! The wires in the power cable of this product are
coloured in accordance with the following code:
Blue = Neutral
If the colours of the wires in the power cable of this product do not
correspond with the terminal markings of your plug, proceed as follows.
•
The wire which is coloured Blue must be connected to the terminal which
is marked N or coloured Black.
•
The wire which is coloured Brown must be connected to the terminal
which is marked L or coloured Red.
Plug must be BS1363/A approved.
Neutral
(Blue)
Ensure that the outer sheath of the cable is firmly held by the clamp
We strongly recommend that this product is connected to the mains supply
via a Residual Current Device (RCD).
If in doubt, consult a qualified electrician. DO NOT attempt repairs yourself.
This symbol indicates that this is a Class II product and does not require
an earth connection.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
Brown = Live
6
Always fit a 13 Amp fuse.
Live
(Brown)