- ページ 5

電動工具 Clarke CPSB1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CPSB1 8 ページ。 Portable sandblaster hopper kit

OPERATION

USING YOUR SANDBLASTER

The compressor used must be at least 3hp and capable of supplying a

minimum of 10 CFM of air

Connect an air hose (sold

separately) from your compressor,

to the hose fitting on the

sandblasting gun. Fig 1.

• Set the air pressure on your air

compressor to 100 -150 psi.

Make sure air hole located on the

base of the hopper is not

covered. Fig 2.

3. Pour the blasting medium into the

hopper.

4. Start compressor according to the

manufacturers instructions.

5. Check for leaks along all hoses

and fittings. if leaks are found, turn

off the compressor, disconnect

the hose and repair immediately.

6. Point the sandblasting gun in a safe direction away from people, pets or

anything around you that may be damaged by direct or indirect abrasive

spray.

7. Press and hold the sandblasting gun trigger until abrasive medium is flowing

through the nozzle.

TO STOP BLASTING

1. Release the trigger on the sandblasting gun.

FIG 1

FIG 2