- ページ 9

電動工具 Clarke CPSB100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CPSB100 20 ページ。 Pressurised sandblaster

LOADING THE ABRASIVE

• To prevent clogging, ensure that the abrasive you use is dry.

• While you may re-use abrasive, remember that abrasive grit/

material does wear out. After use, abrasive becomes smoother and

rounder, thus reducing its effectiveness.

NOTE: Re-using abrasive may also cause clogging due to fine debris

contained in the mixture from prior use.

Close the air supply valve by

turning it to the closed position,

see Fig 7

2. Press safety trigger to release any

pressure from the tank.

• Make sure the pressure gauge

reads "0"

3. Remove the filler cap.

Using the serve and funnel

supplied, pour the selected

abrasive media into the tank, see

Fig 8.

• Do not fill the tank more than

full.

• If humidity in your region is 90%

or more, only fill the tank

and check the water trap more

frequently.

5. Replace the filler cap ensuring the

0-ring is in place.

NOTE: Place your air compressor in another room to prevent damage

from the intake of abrasive dust laden air.

• Choose a larger nozzle for a broader spray pattern. Choose a

smaller nozzle for more focused spray.

• Adjust air pressure with the throttle valve. Adjust abrasive flow with

abrasive control valve,

• Watch for abrasive clogging. Release pressure from the tank if

necessary and replace the abrasive with drier or cleaner abrasive.

Fig 7

full

Fig 8