ページを印刷する
ASSEMBLY
FIT THE PRESSURE GAUGE TO THE TANK
1. Screw the pressure gauge onto
the sandblaster as shown in Fig 1.
FIT THE HANDLE BARS TO THE TANK
1. Lay the tank on a flat level surface
such as a workbench, with the
handlebar mounting brackets
facing up, as shown in Fig 2.
2. Align the holes in the left
handlebar with the handlebar
mounting brackets on the left side
of the tank.
3. Fit a washer onto each of the four
handlebar mounting screws. Insert
a screw through each of the holes in the handlebar and mounting
brackets,
4. Fit a nut onto each of the screws and firmly tighten with a wrench.
5. Repeat steps 2-4 for the right handlebar.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5
Fig 1
Fig 2