- ページ 7

電動工具 Clarke METALWORKER CBS20のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke METALWORKER CBS20 17 ページ。 Electric drill bit sharpener

ELECTRICAL CONNECTIONS

WARNING! Read these electrical safety instructions thoroughly

before connecting the product to the mains supply.

Before switching the product on, make sure that the voltage of your electricity

supply is the same as that indicated on the rating plate. This product is

designed to operate on 230VAC 50Hz. Connecting it to any other power

source may cause damage.

This product may be fitted with a non-rewireable plug. If it is necessary to

change the fuse in the plug, the fuse cover must be refitted. If the fuse cover

becomes lost or damaged, the plug must not be used until a suitable

replacement is obtained.

If the plug has to be changed because it is not suitable for your socket, or due

to damage, it should be cut off and a replacement fitted, following the wiring

instructions shown below. The old plug must be disposed of safely, as insertion

into a mains socket could cause an electrical hazard.

If the colours of the wires in the power cable of this product do not correspond

with the markings on the terminals of your plug, proceed as follows.

• The Blue wire must be connected to the terminal marked N or

coloured Black.

• The Brown wire must be connected to the terminal marked L or

coloured Red.

Neutral

Ensure that the outer sheath of the cable is firmly held by the clamp

We strongly recommend that this machine is connected to the mains supply

via a Residual Current Device (RCD)

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

This symbol indicates that this is a Class II product, and does not require

an earth connection.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Plug must be BS1363/A approved.

(Blue)

Always fit a 3 Amp fuse.

Live

(Brown)