- ページ 15
電動工具 Clarke Metalworker CDP101BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Metalworker CDP101B 19 ページ。 13mm drill press
ページを印刷する
TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
Noisy operation
A) Incorrect belt tension
B) Dry spindle
(under load)
C) Loose pulley
D) Loose belt
E) Worn bearing
Excessive
A) Loose chuck
drill wobble
B) Worn spindle, or bearing
C) Worn chuck
D) Bent drill
A) Power supply
Motor won't
B) Motor connection
start
C) NVR Switch connections
D) Faulty switch
E) Motor windings burned
F) Pulley Cover not closed.
G) Micro Switch inoperative.
Drill binds
A) Excessive feed pressure
in workpiece
B) Loose belt
C) Loose drill
D) Incorrect drill speed.
E) Drill angles incorrect for
type of material
A) Incorrect speed.
Drill burns
B) Chips are not discharging
or smokes
C) Dull drill or incorrect
clearance for material.
D) Needs coolant
E) Excessive feed pressure
Table difficult to
A) Needs lubrication
raise
B) Table lock tightened
REMEDY
A) Adjust tension
B) Remove spindle/quill assembly
and lubricate
C) Tighten pulley
D) Adjust belt tension
E) Replace bearing
A) Tighten by pressing chuck down on
to a block of wood against table.
B) Replace spindle shaft or bearing
C) Replace chuck
D) Renew Drill
A) Check power cord/fuse
B)
Check motor connections
C) Check switch connections
D) Replace switch
E) Replace motor
F) Close pulley cover.
G) Check operation of micro switch,
per instructions Page 10. If switch
operates correctly but motor fails
to start consult your Clarke dealer
A) Apply less pressure
B) Check belt tension
C) Tighten drill with key
D) Refer to Cutting Speed chart,
and adjust drill speed accordingly
E) Consult an appropriate manual
re. Materials, Drills and Cutting
Angles, and sharpen drill
accordingly.
A) Refer to Cutting Speed chart,
and adjust drill speed accordingly
B) Clean drill
C) Check sharpness & profile
D) Use coolant whilst drilling
E) Apply less pressure
A) Lubricate with light oil
B) Loosen clamp
15