- ページ 8

電動工具 Clarke SB30のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Clarke SB30 13 ページ。 Sand blast cabinet

Ensure you comply with all precautions regarding the use of compressed air,

and air compressor operation.

Inspect the abrasive media regularly. If badly contaminated, it should be

replaced. A hinged cover is provided at the base of the funnel to allow quick

draining of the media.

CHANGING THE FLUORESCENT TUBE

Ensure the transformer is disconnected from the power supply before opening

the door and cutting the two ties securing the lamp to its retaining clips.

Carefully pull the lamp from the retaining clips then hold the clear plastic

protective outer tube firmly and ease off the plastic end cover from the non-

wired end. (This may take a little persuasion and perseverance).

Once the end cover has been removed, hold the end cover at the opposite

end (the cable input end), and pull off the outer protective clear plastic tube.

The fluorescent tube is now fully revealed.

Pull off the end connector, which secures a wire to one of the pins, taking care

not to distort the aluminium reflector. Then pull off the wire secured by a plastic

sheath to one of the pins at the cable input end.

Assemble in reverse order, ensuring the wires are correctly held by the plastic

sheath at one end and the end connector at the other, with the reflector

correctly in position.

Re-fit the assembly into its retaining clips and test its operation by plugging the

transformer into the mains.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]