- ページ 4

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

compatible

Vehicle Takeover

Firmware notes

Factory Alarm Disarm: Depending on the Factory Alarm settings, Factory Alarm Disarm may not be available for your vehicle. Test

by arming the vehicle with an OEM remote and unlocking it with a mechanical key. If the alarm disarms, the Factory Alarm Disarm

function is available.

Smart door handles: Not functional during runtime.

Transponder override: This firmware does not support transponder override. One (1) programmed OEM key must be wired into the

vehicle to complete the installation of a remote starter.

Climate controls: Climate controls are key memory sensitive. This means that the last key used to operate the vehicle will determine

the setting for the climate controls. In order to make changes to environment control settings, the following procedure is necessary:

1) Remote start the vehicle.

2) Make your climate control adjustments, ensuring not to use the AUTO mode on the control panel as this

makes the vehicle adjust its HVAC settings based on external factors such as engine temperature.

3) When the adjustments are complete, turn off the vehicle starter, either by remote or footbrake.

Remote Start: To remote start the engine, the hood, the hatch and all doors must be closed.

Remote Starter menu feature "Diesel Start Delay": This feature must be set to Wait to Start for a minimum of eight seconds for

both gas or diesel vehicles to be remote started successfully.

Unless specified otherwise, all connectors are displayed from the wire side.

Refer to the Vehicle connections following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if

not supported in data.

[2] Tach wire: Optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] Key wrap: Refer to the Immobilizer interface section of the guide for additional information.

[4] Handbrake Status: Mandatory connection on automatic and manual transmission vehicles.

403.BMW03 2.47.06 2013 BMW X3 (F25) EU

Vehicle takeover is available but needs to be enabled during module flashing.

Keys required for

Keys required

programming

for operation