- ページ 9

冷蔵庫 Zanussi ZCR135RのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZCR135R 20 ページ。 Zanussi instruction refrigerator zcr135r

ページを印刷する

Something Not Working

Before contacting your local Service Force Centre check the following points:

Symptom

The temperature is too high inside the

refrigerator.

It is too cold inside the refrigerator.

There is water on the cooling plate inside

the refrigerator.

Water is running inside the refrigerator.

Water comes out on the floor.

The compressor operates continuously.

The cabinet does not operate at all.

Cooling or interior light does not

operate. No indicator lamps light.

Noise

If after above checks there is still a fault call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge

if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for in-guarantee service calls.

Set a lower temperature.

Put food products in the right place inside the refrigerator. See

the chapter "Temperature inside the refrigerator".

Distribute the food products to allow cold air to circulate

around them.

Make sure that the door is completely closed and that the

insulating strip is complete and clean.

Set a higher temperature.

Vegetables and other products that are easily frozen have been

placed on a "too cold" shelf. See the chapter "To start the fridge

and thermostat control".

This is normal. During automatic defrosting, frost thaws on the

cooling plate.

Clean the water drain and drain hole inside the refrigerator

using e.g. cotton swabs or a bottle cleaner brush.

Food products could have been placed stopping the water from

running into the drain.

Place the drain hose at the back of the cabinet above the drain

bowl. See the chapter "Before use"

Set a higher temperature.

Make sure that the door is completely closed and that the

insulating strip is complete and clean.

The power plug is not properly connected.

The fuse has blown.

The cabinet is not switched on.

Power does not reach the cabinet. (Try connecting another

electrical device to the power outlet.)

See "Normal operating Sounds" in chapter

Hints and Tips.

If the cushion spacers (between the cabinet wall and pipes)

come loose, put them back in place again.

Carefully follow the instructions in the chapter "Installing the

cabinet".

Solution

Zanussi 818 14 54-03/7