- ページ 16

冷蔵庫 Zanussi ZERB 2420のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZERB 2420 20 ページ。 Zanussi instruction booklet refrigerator- freezer czf 145 w

ページを印刷する

1. Technical Specification

INSTALLATION

Please ensure that when the appliance is

installed it is easily accessible for the engineer in

the event of a breakdown.

Important

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate, which

is located at the left on the inside of the appliance.

The following table shows which ambient temperature is

correct for each climate classification:

+10°C to + 32°C

+16°C to + 32°C

+18°C to + 38°C

+18°C to + 43°C

It should be located in a dry atmosphere, out of direct

sunlight and away from extreme temperature e.g. not

next to a boiler or radiator, or in a very cold room e.g. an

outhouse, where the temperatures may fall below 10°C

(50°F). If these temperatures are exceeded i.e. colder or

warmer, then the appliance may not operate correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There must

also be at least 100 mm (4") distance between the top of

the cabinet and any overhanging kitchen furniture (A).

Ideally, the appliance should not be positioned beneath

overhanging furniture (B).

There should also be a gap of 25 mm either side of the

appliance. Do not obstruct the space underneath. The

back of the cabinet may be placed close to the wall but

must not touch it. DO NOT install in places with

restricted ventilation.

Adjust the level of the appliance by screwing out the

adjustable foot, or feet, at the bottom of the cabinet

using your fingers.

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be fitted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in the

diagram. Then turn them through 45° (arrow (A)

vertical) until they lock into place.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on "Door reversal".

NP002

D200

45°

PR60