- ページ 12
冷蔵庫 Zanussi ZFCA 62/26のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZFCA 62/26 12 ページ。 Zanussi refrigerator user manual
ページを印刷する
MAINTENANCE AND CLEANING
Prior to undertaking any maintenance operation, be
sure to unplug the appliance from the wall socket as
a safety precaution.
Clean the interior periodically with lukewarm
water and some bicarbonate of soda; the cabinet
exterior with a Silicone wax spray; the condenser
and the motor compressor with a brush or a vacuum
cleaner.
The defrost water drain hole in the fridge
compartment should be cleaned at regular
intervals. To do this, use the special cleaner
provided, which you will find already inserted in the
discharge hole (Fig. 13).
D037
During periods when the appliance is not in use,
take the following precautions:
unplug the appliance from the power supply;
remove all foodstuffs from the appliance;
clean the interior and all accessories;
leave the door ajar to facilitate the circulation of air
in the interior of the cabinet so as to prevent
unpleasant odours from accumulating in the
appliance.
SERVICING
Should service be required for this appliance,
contact your local ZANUSSI Service Centre.
Before requesting service the following simple
checks may save you inconvenience and expense:
If there are water drops on the bottom of the fridge
compartment, check that the defrost water drain
opening is not obstructed.
Check that the plug is firmly in the wall socket.
Check that there is an electricity supply to the
socket by plugging in another appliance and
operating it.
If it is felt that the compressor may be faulty turn
the thermostat knob to the coldest setting and,
leaving the door open also for a few minutes, listen
to check if the motor then runs and see if the
12
Fig. 13
Replacing the interior light bulb
Prior to undertaking this operation, be sure to unplug
the appliance from the wall socket as a safety precaution.
If the interior light does not come on when the door
is opened, you will need to gain access to the
interior light bulb. To do this, remove the bulb
housing cover by unscrewing the screw and by
sliding it out (Fig. 14). Check that the bulb is
correctly screwed into its socket. If it is burnt out,
replace with a similar bulb. The maximum rating of
the bulb is indicated on the housing cover. Replace
the cover by sliding it back in. Fasten it by means of
the previously removed screw.
D206
Spare bulbs can be obtained from your local
ZANUSSI Service Centre.
evaporator frosts over. If the motor still does not
run or frost does not form on the evaporator contact
your ZANUSSI Service Agent.
In-guarantee customers should ensure that the above
checks have been made as the engineer will make a
charge if the fault is not a mechanical or electrical
breakdown.
Please note that proof of purchase is required for any in-
guarantee service calls.
Fig. 14