ページを印刷するOpen both the appliance door and that of the
kitchen unit to approx. 90 .
Place the little plates over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
8mm
PR34
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
PR35
44
Fig. 9
Fig. 10
If the appliance is fixed to the side of the kitchen
unit, simply slacken the screws in fixing brackets
(F), move the brackets as shown in the figure and
re-tighten the screws.
Then fit cover (G).
D398
Fig. 11
F
G