ページを印刷する
Door reversibility
Before carrying out any operations, remove the
plug from the power socket.
To change the opening direction of the door,
proceed as follows:
1. pull off the vontilation grille (D) which is clipped
into place;
2. remove the hole cover (G) and the bottom hinge
(E) by unscrewing its three fixing screws;
3. remove the lower door, sliding it out of the
middle hinge;
4 unscrew the middle hinge (H);
5. remove the upper door, releasing it from the
upper pin (G);
6 unscrew the upper pin (G) and refit it on the
opposite side;
7. remove the two plugs of the door (where
available), discovering the holes for the hinge
pins, assemble them on the opposite side and
refit the upper door;
8. reassemble the middle hinge on the opposite
side;
9. using a 10 mm spanner, unscrew the hinge pin
(E) and reassemble it on the opposite side of the
hinge;
10.reassemble the lower hinge (E) on the opposite
side, using the screws previously removed;
insert the hole cover (G) on the lower hinge.
Slide the hole cover (F) out of the ventilation
grille (D) by pushing it in the direction of the
arrow and reassemble it on the opposite side;
11.reassemble the lower door;
12.refit the ventilation grille (D), clipping it into
place.
To line up the doors, it is possible to adjust the
middle hinge (H) horizontally by means of a toll,
after slackening the two screws (see figure).
Warning:
After having reversed the opening direction of the
doors check that all the screws are properly tightened
and that the magnetic seal adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
D590
H
PR24
E
F
D
F
PR18
D419
G
G
E
F
5