- ページ 8
冷蔵庫 Zanussi ZQA14031DVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZQA14031DV 13 ページ。
ページを印刷する
Problem
The compressor operates con-
tinually.
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much condensed
water on the rear wall of the re-
frigerator.
8
Possible cause
Temperature is set incorrectly.
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Solution
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Open the door only when nec-
essary.
Make sure the door is closed
completely.