- ページ 11

冷蔵庫 Zanussi ZRB324WO1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZRB324WO1 30 ページ。

ページを印刷する

The plastic bag of accessories also contains two

spacers to be fitted into special holes in the back of the

appliance. Fit the spacers into the holes, taking care to

ensure that the spacer is positioned as shown in Figure.

Then turn them through 45° until they lock into place.

Do not stand the appliance on a sunny place or close to

a radiator or cooker.

If it is unavoidable because of furnishing and the

appliance has to be stood near a cooker take these

minimum distances into consideration: In case of gas

or electric cooker 3 cm must be left, when it is less

put a 0,5 - 1 cm non-flam insulation between the two

appliances.

In case of oil or coal-fired stove the distance must be 30

cms since they give off more heat.

The refrigerator is designed to operate when it is totally

pushed to the wall.

When placing the refrigerator keep minimal

distances recommended in figure.

A: placing it under a wall-cupboard

B: placing it freely

Change of door opening direction

–

Take off thermostate button from front of the work

plate. (Picture 4). Unstick the label from front of

the work plate. Remove the refrigerator work plate

(Picture 5).

–

Unscrew the upper door hinge of the refrigerator, and

then screw it back on the other side (Picture 6).

–

Remove the screws of the lower door hinge on

the left side and screw it back on the other side of

refrigerator (Picture 7).

–

Fit the lower door to the lower door hinge.

Should the setting-up place

or handling demand it, door

opening direction can be refilled

from right-handed to left-handed.

Appliances on the market

are right-handed. Following

operations are to be done

on the basis of figures and

explanations:

–

Disconnect the appliance from

the electricity supply.

–

Tilt back the appliance

carefully. It is recommended

to ask another person for help,

who can keep the appliance at

this position safely.

–

Remove cover from the upper

door mask and remove upper

door shaft (Picture 1).

–

Take off the upper door by

pulling it slightly upwards.

–

Dismount the double door

holder by removing two

screws in front (Picture 2)

–

Take off the lower door by

pulling it slightly upwards

and remove plastic door

limiter from the bottom of

the both doors by removing

the screw. Install left door

limiter, enclosed in the bag

of spare parts, on both doors

(Picture 3)