- ページ 9

冷蔵庫 Zanussi ZRME38FW2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZRME38FW2 24 ページ。

When the door of the fridge is closed, a vacuum

seal will form. Wait for 1 minute before reopening it.

This application is optional for easy opening of the

door. With this application, a little condensation may

occur around this area and you may remove it.

Installing and operating your fridge

Before using your fridge for the first time, please pay attention to the following points:

• The operating voltage for your fridge is 220-240 V at 50Hz.

• The plug must be accessible after installation.

• Your fridge may have an odour when it is operated for the first time. This is normal and

the odour will fade when your fridge starts to cool.

• Before connecting your fridge, ensure that the information on the data plate (voltage

and connected load) matches that of the mains electricity supply. If in doubt, consult a

qualified electrician.

• Insert the plug into a socket with an efficient ground connection. If the socket has no

ground contact or the plug does not match, we recommend you consult a qualified

electrician for assistance.

• The appliance must be connected with a properly installed fused socket. The power

supply (AC) and voltage at the operating point must match with the details on the name

plate of the appliance (the name plate is located on the inside left of the appliance).

• We do not accept responsibility for any damages that occur due to ungrounded usage.

• Place your fridge where it will not be exposed to direct sunlight.

• Your fridge must never be used outdoors or exposed to rain.

• Your appliance must be at least 50 cm away from stoves, gas ovens and

heater cores, and at least 5 cm away from electrical ovens.

• Do not cover the body or top of fridge with lace. This will affect the

performance of your fridge.

• Top clearance required for the appliance can be derived from dimensions

provided in chapter Dimensions.

• Do not place heavy items on the appliance.

• Use the adjustable front legs to make sure your appliance is level and stable. You can

adjust the legs by turning them in either direction. This must be done before placing food

in the appliance.

• Clean the appliance thoroughly before use (see Cleaning and Maintenance).

• Before using your fridge, wipe all parts with a solution of warm water and a teaspoon

of sodium bicarbonate. Then, rinse with clean water and dry. Return all

parts to the fridge after cleaning.

• Install the two plastic distance guides (the parts on the black vanes

-condenser- at the rear) by turning it 90° (as shown in the figure) to

prevent the condenser from touching the wall.

• If you position the appliance against a wall in a freestanding installation,

install the rear spacers in order to guarantee the maximum possible

distancedistance

EN -9-