- ページ 9

電動工具 Clarke X-Pro CAT213のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke X-Pro CAT213 17 ページ。 Air nibbler

OPERATION

The punch and die can be rotated through 360

maximum consumable life.

1. To do this, loosen the locknut with

a 22 mm spanner and rotate the

die on the blade until it is in the

right position for the job in hand.

2. Hold the die steady with a 15mm

spanner on its flats and retighten

the locknut.

3. Ensure your workpiece is properly

secured and marked out.

4. Connect the nibbler to the airline.

5. Start the nibbler by squeezing the throttle lever.

6. Introduce the sheet metal into the slot in the end of the die. Apply only light

pressure to move the tool in the desired direction through the material.

7. Do not allow the nibbler to run freely for long periods of time as this could

harm the bearings.

It is recommended that a whip hose with a swivel (not included) be used to

prevent twisting, kinking and resultant wear to the air hose.

CHANGING THE BLADE AND DIE

1. Loosen the locknut using a 22mm

spanner.

2. Unscrew the die (with the locknut

on it) from the body of the tool.

3. Using a 9mm ring spanner, unscrew

the blade retainer with the blade.

4. Remove the old blade from the

retainer and insert the new one.

5. Screw the retainer back into place

and tighten with the ring spanner.

6. Slide the die and locknut over the

blade and screw it back into the

tool until the tip of the blade is flush

with the bottom of the die. Rotate

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

to aid access and obtain