- ページ 16
オーブン Zanussi ZOD35661WKのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZOD35661WK 21 ページ。 Built-in double oven
Zanussi ZOD35661WK にも： ユーザーマニュアル (21 ページ), ユーザーマニュアル (20 ページ)
ページを印刷する
WARNING! Be careful when you
remove the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on the two
door hinges.
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a soft
cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
CAUTION! Rough handling of the
glass, especially around the edges of
the front panel, can cause the glass to
break.
16
A
1
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
9. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, do the above
steps in the opposite sequence. Install the smaller
panel first, then the larger and the door.
WARNING! Make sure that the
glasses are inserted in the correct
position otherwise the surface of the
door may overheat.
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.