- ページ 16

オーブン Zanussi ZOD580のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZOD580 28 ページ。
Zanussi ZOD580 にも：ユーザーマニュアル (24 ページ)

ページを印刷する

Accessories

• Clean and dry the oven accessories (shelf, tray, roast-

ing pan, etc.) after each use. Soak the items to make

cleaning easier.

Catalytic cavity cleaning

Warning! You must not wipe out the cavity side

walls. It will damage the catalytic surface.

1. Remove all slide-in parts from the oven.

2. Wipe the floor of the oven clean with warm washing-

up solution and dry.

3. Set the oven with max temp. of 275˚C for 30 min (use

Conventional Cooking or Thermaflow® function).

4. Oven will switch off after one hour.

5. Wipe away any remaining a damp from the floor with

soft sponge.

Warning! Before you wipe away wait until the cavity

is cool.

Warning!

Do not use oven spray or abrasive cleaning agents. Do

not use soap or other cleansing agents. The catalytic

coating may otherwise be damaged.

After long periods of use, the catalytic coating may

become slightly discoloured. This has no effect on

the catalytic properties.

Side rails

The side rails on the right and left-hand side of the oven

interior can be removed for the purpose of cleaning the

side walls.

Removing the side rails

Pull the rails away from the

oven wall at the front

(selected models only)

Unhook them at the back

Replace the side rails

Important! Important The rounded ends of the guide bars

must point to the front.

To install, first (1) and then .

Insert the rails in the holes

at the back

Oven back lamp (for selected models only)

Warning! Risk of electric shock! Before replacing

the oven light bulb:

– Switch oven off.

– Unscrew the fuse from the fuse box or switch fuse off.

To protect the oven light bulb and the glass cover,

lay a cloth on the floor of the oven.

Replacing the oven light bulb/Cleaning the glass cover

1. Take off the glass cover by turning it anticlockwise

and clean it.

2. If necessary:

replace with a 40 Watt, 230V, 300°C heat-resistant

oven light bulb .

3. Refit the glass cover.

Lower into position at the

front and press them at the

back