- ページ 17
オーブン Zanussi ZOF35712XのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZOF35712X 20 ページ。
Zanussi ZOF35712X にも： ユーザーマニュアル (20 ページ), ユーザーマニュアル (24 ページ)
ページを印刷する
45°
4. Hold the door with one hand on each side
and pull it away from the appliance at an
upwards angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to
prevent scratches.
6. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges of the
front panel, can cause the glass to
break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is completed, install the
glass panels and the door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
www.zanussi.com
1
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp. The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the back
of the cavity.
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
The side lamp
1. Remove the left shelf support to get access
to the lamp.
2. Use a narrow, blunt object (e.g. a teaspoon)
to remove the glass cover.
3. Clean the glass cover.
4. Install the glass cover.
5. Install the left shelf support.
17