- ページ 5

洗濯機 Zanussi AquaCycle 1000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi AquaCycle 1000 20 ページ。 Washing machine f1000

Installation

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all transit devices so that

they can be refitted if the machine ever has to be

transported again.

1. Using a spanner, unscrew and remove the two

rear bottom screws. Slide out the two plastic pins.

Lay the machine on its back, taking care not to

squash the hoses. This can be avoided by

placing one of the corner packing pieces between

the machine and the floor.

2. Remove the polystyrene blocks from the bottom

of the machine and release the two plastic bags.

3. Very carefully slide out the left polythene bag,

removing it towards the right and then

downwards.

4. Very carefully slide out the right polythene bag,

removing it towards the left and then upwards.

5. Set the machine upright and remove the

remaining rear screw. Slide out the relevant pin.

6. Plug all the holes with the plugs which you will

find in the envelope containing the instruction

manual.

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is

not impeded by carpets, rugs etc. Check that the

machine does not touch the wall or other kitchen

units.

Carefully level by screwing the adjustable feet in or

out. Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor.

Connect the water inlet hose to a tap with 3/4" BSP

thread.

Use the hose supplied with the washing machine.

DO NOT USE OLD HOSES.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply

loosen the fitting, rotate the hose and retighten the

fitting, making sure there are no water leaks.