- ページ 8

洗濯機 Zanussi FJS 1276のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi FJS 1276 23 ページ。 Washing machine
Zanussi FJS 1276 にも：取扱説明書 (22 ページ)

Water inlet

Connect the water inlet hose to a tap with a 3/4"

thread spout.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply loosen

the fitting, rotate the hose and retighten the fitting,

making sure there are no water leaks.

The inlet hose must not be lengthened. If it is too short

P0351

P0021

and you do not wish to move the tap, you will have to

purchase a new, longer hose specially designed for

this type of use.

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the plastic

hose guide supplied with the machine. In this case,

make sure the end cannot come unhooked when the

machine is emptying.

This could be done by tying it to the tap with a piece

P0022

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm

above the ground.

Directly into a drain pipe at a height of not less than

60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated,

i.e. the inside diameter of the drain pipe must be

larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the

P0023

floor; only the part near the drainage point must be

raised.

Waterstop

The inlet hose is provided with a water stop device,

which protects against damages caused by water

leaks on the hose itself which could develop due to

natural ageing of the hose. This fault is shown by a red

sector on the windows "A".

Would this occour, turn the water tap off and refer to

your Service Agent to replace the hose.

P1045